Titanium

[whitesnake]

I have a Ruger 44 mag. Ultra light in Titanium and can not seem to get it cleaned. Is there any way at all to clean the darn thing. I am very aggitated with it triing to get it clean. Any and all suggestions would be very appreciated.
Doug:( :confused: :irked:

[Caribou Dreamer2]

Well might not be able to help with titanium ,but my 44 mag is stainless,But this is what i do to keep my clean just like when i bought it.
First when i get home from the range i will spray it with a good cleaner.I use Rusty duck bore cleaner.Some say break cleaner is the same but cheaper????Not sure about that one.Then after about a few hours i will go back and use a tool brush and scrub the ports and the cylinder after that is clean i will use Rusty duck gun lubrication and spray the cylinder and trigger.Once that is done i will wipe the whole gun down with Hoppe's gun oil then put in holster for the next trip.
Good luck and i hope this helps out.But everybody uses there own oils and cleaners so i'm sure you will get a wide choice.

[johnch]

Sure it is not either a Stainless Ruger Or Ti Tauses ?

If you need to get the carbon ( black in front of the cylender )
Get a treated cloth called Lead Wipe Away cloth .
Looks like a silcone cloth .

I cut it into 2" squares and keep them in a zip lock bag .
If allowed to dry out .
It will not work


BUT DO NOT USE IT ON A BLUE GUN ( except for inside the bore )
If you use it on a blue gun , you will remove the blueing :yikes: :yikes:

Johnch

[whitesnake]

Thanks for the help I will have to try this out.